0Ajuste de la configuración del enchufe inteligente tasmota

I’ve now got around 30 tas­mota-based smart plugs around the house. I’ve recently been tinker­ing with the set­tings on a few to optim­ise them for the roles they have

The first thing I wanted to do was to tweak the energy mon­it­or­ing plugs I have (from Loc­al­Bytes) so they report energy use more pre­cisely. Whilst it is pos­sible to adjust how often they report, a smarter way to do this is to adjust what level of power change will trig­ger an update. Hay 2 ways to do this — either as a per­cent­age or as an abso­lute. Go to the com­mand line and enter one of the fol­low­ing (chan­ging the 10 part to whatever value you require)

Power­Delta 10 = Update MQTT on 10% cambio
Power­Delta 110 = Update MQTT on 10W change

The next thing I wanted to tweak was the sleep time as most of my plugs can sleep more than the default. The default is a smartsleep mode which works well and for devices where I often press the but­ton I have left the default. But for devices where I don’t press the but­ton I increased the value with the following

Dormir 250

Note it is not advised to change this for plugs you do press — the default value of 50 works well for these. Fur­ther it is not advised to change this for energy mon­it­or­ing plugs

To see the cur­rent value simply type the com­mand without a num­ber after it.

I tend to use Power­Delta 104 and Sleep 50 for power mon­it­or­ing devices, Dormir 50 for devices where I press the but­ton reg­u­larly, and Sleep 250 for oth­er plugs

Creo que hemos perdido algo? Avísenos comentarios a continuación. Si desea suscribirse por favor utilice el enlace de suscripción en el menú en la parte superior derecha. También puede compartir esto con tus amigos mediante el uso de los enlaces sociales inferiores. Aclamaciones.

Deja una respuesta